Download PDF of Introduction to Solid Modeling Using SolidWorks 2016 by William E. Howard and Joseph

In addition to the experimental tests, thermal modeling has also been conducted to verify and predict the temperature profiles for the test piece. Heat transfer based modelling and simulation has been conducted using Solidworks 2013. The test piece is modeled for convective heat transfer on both sides assuming air and water as the convective fluids. Natural convection is assumed. Conduction heat transfer is considered inside the solid test piece. A sample set of simulation results are shown in Figure 8 and Figure 9. The air side temperature is fixed at 100 F and the heat transfer analysis is performed to obtain the bulk mean temperature of water on the other side. Figure 8 represents the heat transfer through the plate/wall and Figure 9 represents the detailed temperature profile along the cross section of the plate/wall for typical cases.

Introduction to Solid Modeling Using SolidWorks 2016 download pdf

Download

2ff7e9595c